BELT PRESS EDOM

EDOM belt presses cover a small-medium range (500 to 1300 mm width), used in small municipalities and industries with their water treatment plants.

Standard production is made with frames in hot dip zinc coated carbon steel, rollers and tank in AISI 304 SS.

On request, EDOM may be made entirely in AISI 304 SS or AISI 316 SS.

Belt presses can be supplied with self cleaning nozzles system, making it possible the use of water from clarifiers.

BELT PRESS EDOM/L

EDOM/L Belt presses with a pre-gravity zone and a sludge turnover, in size from 500 to 1200 mm belts width.

This model is particularly apt for sludge with a low solids content (below 1.5% SS).

Achieved capacity increases are up to 50% compared to the same standard belt press EDOM.

BELT PRESS EDOM AND CAB

After a twenty years long experience of units installed all over the World, INTERECO produce belt press to 3000 mm belts width.

Apt for any type of sludge:

Biological, chemical, paper milk dairy, inert and tanneries.

To save money for the shipment, it is no necessary to use wood cages. For a belt press CAB 2000 is enough a 20” Flat Rack. Belt press EDOM and CAB 2500-3000 are divided in two parts, to be assembly in site. Also for these reasons, INTERECO is more cheaper than our Competitors.

loading

By continuing to use the site, you agree to the use of cookies. maggiori informazioni

The cookie settings on this website are set to "allow cookies" to give you the best browsing experience possible. If you continue to use this website without changing your cookie settings or you click "Accept" below then you are consenting to this.

Close